University of Sydney Thesis Format Guide

The University of Sydney maintains specific formatting standards for all graduate research theses and dissertations across all faculties. This comprehensive guide covers Sydney’s formatting requirements.

Page Setup and Margins

Sydney’s margin requirements accommodate binding and archival preservation while maintaining optimal readability.

Left Margin: 40mm (approximately 1.57 inches) - Required for binding and annotation space.

Right Margin: 20mm (approximately 0.79 inches) - Provides adequate white space.

Top Margin: 20mm (approximately 0.79 inches) - Applied consistently across pages.

Bottom Margin: 20mm (approximately 0.79 inches) - Maintains spacing for page numbers.

Paper Size: A4 (210mm x 297mm) is the standard.

Page Orientation: Portrait (vertical) orientation throughout.

Setting Margins in Word: Page Layout > Margins > Custom Margins (left: 40mm, right: 20mm, top: 20mm, bottom: 20mm).

Font Requirements

Sydney maintains clear font and spacing specifications for thesis preparation.

Body Text Font: Times New Roman in 12-point size is standard. Other serif fonts are acceptable.

Line Spacing: Double-spacing (2.0) is required for all body text.

Footnotes and Endnotes: May be single-spaced (1.5) in 10-point font.

Font Consistency: Use the same font throughout body text.

Headings: Chapter headings in 14-point bold, section headings in 12-point bold, subsection headings in 12-point bold italic.

Tables and Figures: May use fonts as small as 10-point if necessary.

Title Page Format

Your title page is the formal introduction to your thesis and must follow Sydney’s specifications.

Required Elements:

• Thesis title
• Author name
• University of Sydney
• Degree (e.g., Doctor of Philosophy)
• Faculty/School
• Date of submission

Layout: Center all elements. Place title prominently, with author name and submission information appropriately spaced.

Page Numbering: The title page is not numbered, though it counts as page i.

Line Spacing: Single-spacing for the title page.

No Headers or Footers: Omit headers and footers from the title page.

Abstract Requirements

The abstract is a concise summary of your research.

Length: 300-500 words for most Sydney theses.

Content: Summarize your research problem, methodology, findings, and significance using past tense and third person.

Page Placement: The abstract should appear on its own page following the title page.

Title: Center “ABSTRACT” at the top in capitals.

Page Numbering: Use lowercase Roman numerals (ii, iii, etc.) for the abstract page.

Formatting: Double-spaced, using the same font and size as body text.

Table of Contents

Your table of contents provides an overview of your thesis structure.

Format: Include all chapter titles and major sections with page numbers.

Page Numbers: Use lowercase Roman numerals for front matter and Arabic numerals for body pages.

Title: Center “CONTENTS” at the top in capitals.

Formatting: Double-spaced with dot leaders connecting headings to page numbers.

Automatic Generation: Use Word’s References > Table of Contents.

Heading Styles and Hierarchy

Consistent heading hierarchy improves readability.

Chapter Headings (Level 1): 14-point bold, all capitals or title case, centered. Begin on new page.

Section Headings (Level 2): 12-point bold, title case, left-aligned.

Subsection Headings (Level 3): 12-point bold italic, title case, left-aligned.

Paragraph Headings (Level 4): 12-point bold, run-in style.

Consistency: Use Word’s Styles gallery for all headings.

Page Numbering

Proper page numbering follows Sydney conventions.

Front Matter: Use lowercase Roman numerals (i, ii, iii, iv). Title page not numbered but counts as page i.

Body Text: Begin Arabic numerals (1, 2, 3) with introduction or first chapter.

Appendices: Continue Arabic numerals through appendices.

Page Number Location: Place in upper right corner or center at bottom. Be consistent.

Implementation: Use Insert > Page Numbers with Section Breaks between front matter and body.

Citation Style Requirements

Sydney permits different citation styles by discipline.

Engineering: IEEE style is standard.

Sciences: APA or Harvard referencing is common.

Humanities: Chicago Manual of Style (footnotes/endnotes) is typical.

Social Sciences: Harvard or APA are both acceptable.

Verification: Always check with your school for specific requirements.

Using GenText: GenText’s citation generator supports IEEE, APA, Chicago, Harvard, and other major formats.

Figure and Table Formatting

All figures and tables must be professionally formatted.

Table Titles: Place above tables in 12-point font. Number sequentially or by chapter.

Figure Captions: Place below figures in 12-point font.

Source Citations: Include sources for all data.

Sizing: Tables and figures must fit within margins.

Integration: Embed in text near where referenced.

Lists: Include lists of figures/tables if you have more than 5.

Bibliography and References

Your bibliography is a complete record of all sources cited.

Organization: Arrange alphabetically by author’s last name.

Completeness: Include all sources cited; include only sources referenced.

Title: Center “BIBLIOGRAPHY” or “REFERENCES” in capitals.

Formatting: Use hanging indentation. Double-space throughout.

Appendices

Appendices contain supplementary material supporting your thesis.

Labeling: Label as “Appendix A,” “Appendix B,” etc.

Page Numbering: Continue Arabic numerals from main text.

Table of Contents: Include in your table of contents.

Content: Include supplementary materials like data, calculations, or questionnaires.

Formatting: Apply same formatting as main text.

Electronic Submission Requirements

Sydney requires electronic submission through the research portal.

File Format: Submit as PDF with embedded fonts.

Accessibility: Ensure PDFs are accessible with proper heading hierarchy.

File Naming: Follow Sydney conventions, typically: LastName_FirstName_PhD_2026.pdf

Metadata: Include thesis title, author, degree, and year.

Submission Deadline: Check the Graduate School website for deadlines.

Embargo Option: Request embargo periods if necessary.

Tips for Formatting in Microsoft Word

Create Custom Styles: Define styles before writing.

Use Section Breaks: Separate front matter from body text.

Configure Headers and Footers: Set different settings for different sections.

Insert Page Breaks: Use Ctrl+Enter for new chapters.

Manage Footnotes: Use References > Footnotes.

Generate Table of Contents: Use References > Table of Contents.

Verify Margins: Check via Page Layout > Margins before finalizing.

Related Resources and Tools

GenText provides resources for thesis formatting and citation management.

GenText Citation Generator: Supports IEEE, APA, Chicago, Harvard, and other formats.

Word Formatting Tutorials:

• How to Format a Thesis in Word
• How to Create and Update a Table of Contents
• How to Use Section Breaks for Different Page Numbering
• How to Create Custom Heading Styles

Conclusion

Proper thesis formatting at Sydney demonstrates professionalism and academic integrity. Use Word’s formatting tools effectively, create custom styles early, and reference this guide throughout your thesis.

For the most current information on Sydney thesis requirements, consult the University of Sydney Graduate School website. School-specific requirements may vary, so always verify with your supervisor.

With careful attention to these requirements, your thesis will meet all Sydney standards and present your research professionally.